stlku 0 Posted August 4, 2014 Mike, I lost my old spreadsheet and can't import my old settings. I tried to reenter them but i can't seem to get my baselines set correctly. Any suggestions on how you would set the baselines with the following rules? We have 3 active WR and it seems like my RB rankings are way to high. 18 player max POSITION ACTIVE MIN ACTIVE MAX ROSTER TOTAL QB 1 1 RB 1 1 WR 3 3 TE 1 1 RB-WR-TE 1 1 K 1 1 DST 1 1 SCORING SYSTEM SCORING FOR OFFENSIVE CATEGORIES NAME SETTINGS FG Field Goals 3 points FL Fumble Lost, Including ST plays -2 points Pa2P Passing Two-point Conversion 2 points PaInt Passing Interception -2 points PaTD Passing TD 6 points PaYd Passing Yards 1 - 1000 PaYds = .04 points for every 1 PaYd Plus a 5 point bonus @ 300+ PaYd Re2P Receiving Two-point Conversion 2 points ReTD Receiving TD 6 points ReYd Receiving Yards 1 - 1000 ReYds = .1 points for every 1 ReYd Plus a 5 point bonus @ 100+ ReYd Recpt Reception 1 - 1000 Recpts = .5 points for every 1 Recpt Ru2P Rushing Two-point Conversion 2 points RuAtt Rushing Attempt .25 points RuTD Rushing TD 6 points RuYd Rushing Yards 1 - 1000 RuYds = .1 points for every 1 RuYd Plus a 5 point bonus @ 100+ RuYd XP Extra Points 1 point Thanks Share this post Link to post Share on other sites
Mike MacGregor 20 Posted August 4, 2014 Hi stlku. Hmm… well, not sure why RB are getting overvalued, but from the settings shown should be: starters QB = 1, RB = 1, WR = 3, TE = 1 , K = 1, O-Flex = 1, DEF = 1 bench (9) QB = 1, RB = 2, WR = 3, TE = 1, K = 1, DEF = 1 Make sure to check off all of RB, WR and TE as being included in the flex. Since you only start 1 RB vs. 3 WR before the flex, the flex spot probably will be most running backs. Is this similar settings to what you have? Share this post Link to post Share on other sites
stlku 0 Posted August 4, 2014 yes the only changes i made were to the back ups I only put in 1 kicker and 1 def as starters and no backups. I added one WR and one RB to my bench. I was playing around with the baselines to see how if I could bump up my WR to put a bit more importance on that position since they seemed low in rankings. With all the baselines set at 1.0 the first WR was ranked at #21 overall which seemed low. Would you keep it at that or adjust the WR baseline up? Share this post Link to post Share on other sites
Mike MacGregor 20 Posted August 5, 2014 In a lot of leagues I would set backup K and DEF to 0, but in your case you have a lot of backups relative to the starters. I would start by putting 1 in each of those positions instead of the additional RB and WR, and run the results and see what you get from that. While half a point per reception is not a ton, I would think the WR should be pretty well distributed amongst the RB in the Top 20. Share this post Link to post Share on other sites